QRCODE — QR code

Draws a QR code; error-correction level, cell size, encoding mode and rotation are read from the parameters.

Engine status: Partially rendered

The command is drawn but some of its parameters are ignored; the detail is in the note below.

Syntax

QRCODE x, y, ecc, cell, mode, rot, "data"

Example

SIZE 100 mm, 150 mm
GAP 3 mm, 0 mm
CLS
QRCODE 100, 400, M, 6, A, 0, "https://..."
PRINT 1

Open this example in the preview →

Open the validator →

Rendered example

QRCODE 100, 400, M, 6, A, 0, "https://..."

Output of the example above in our renderer (203 dpi). Not verified on a physical printer.

Parameters

Parameter	Meaning
`x, y`	Top-left corner of the QR code, in dots
`ecc`	Error-correction level L, M, Q or H; other values fall back to M
`cell`	Module (cell) size in dots
`mode`	Encoding mode letter; accepted but not used by the Labelixa preview
`rot`	Rotation in degrees clockwise: 0, 90, 180 or 270
`"data"`	QR content in double quotes

Common mistake

Leaving the data unquoted: fields are split at commas outside quotes, so an unquoted URL that contains a comma is cut at the first comma. Always quote the data.

The same job in other languages

ZPL equivalent: ^BQ · Language comparison

All TSPL commands

SIZE · GAP · REFERENCE · CLS · TEXT · BARCODE · BOX · BAR · BITMAP · PRINT · DIRECTION · DENSITY · SPEED · OFFSET · SET · CODEPAGE · BLINE

All TSPL commands